Steel

echnical Requirements For Clad Steel-Alu Explosive Transition Joint

Sep 24, 2022

1.Each batch must have ultrasonic inspection certificate. 2.Sampling inspection finished products 2 ~ 3%, fusion surface not less than 98%. 3. The tensile strength of contact surface shall not be less than 120MPa. 4.The shear strength of con

Aluminum to stainless steel transition fittings

Sep 17, 2022

aluminum specializes in the production of composite materials and has accumulated a lot of experience in aluminum-steel composite. At the same time, it has two processes of rolling composite and explosive composite, which are widely u

aluminum clad steel plates

Jul 21, 2022

The aluminum clad steel plates is a typical layered metal composite material, which has a wide range of application prospects in the fields of ships, chemicals, aerospace, etc. Its thickness specifications range from 0.1mm (such as radiator

Aluminum Clad Steel Bimetal

Jun 20, 2022

Aluminum Clad Steel Bimetal Aluminum bimetal .....

Pre-baked anode steel claw protection ring

May 15, 2022

Including the following steps: 1) cleaning: clean the debris on anode carbon block and anode steel claw ; 2) make anti-oxidation protective cover: use kraft paper to make a cylindric anti-oxidation protective cover and set it on the anode st

Explosion Welding Aluminium Steel Structural Transition Joint

Apr 19, 2022

Explosion Welding/Bonding/Cladding Aluminum Steel Structural Transition Joint , as the metal composite material, is widely used in electrolytic aluminum industry and metallurgy industry. Adopting the new explosive welding method, it integra

cast steel anode yoke

Apr 14, 2022

The cast steel anode yoke is an indispensable device in the anode guide rod in the electrolytic aluminum production process, which plays a role in connecting the upper and lower parts. The anode guide rod has an aluminum guide rod above and

Anode steel claw

Feb 22, 2022

Anode steel claw for electrolytic aluminum is also called electrolytic claw. There are three parallel claws, four claws, three-dimensional four claws, six claws, eight claws, double anode steel claw s, etc. Lost foam casting production line

aluminum-steel transition insert

Dec 28, 2021

A transition layer with relatively low hardness was formed in the explosive clads of aluminium and low carbon steel. The auminum-steel transition insert layer is mainly composed of FeAl6 phase. At this time, no martensite layer was formed. I

Process of Prebaked Anode Steel Claws for Electrolytic Aluminum

Dec 09, 2021

Introduction of Process of Prebaked Anode Steel Claws for Electrolytic Aluminum With the rapid development of aluminum electrolysis technology, the anode used in electrolytic aluminum has also transitioned from self-baking anode to pre-baked

Aluminium Stainless steel transition joints

Oct 08, 2021

Aluminum and aluminum alloy products are widely used in air separation and other low-temperature devices because of their excellent performance in low-temperature environment. However, the welding (connection) between aluminum vessel or devi

Explosion welding titanium steel clad plate

Aug 06, 2021

Titanium is widely used as various chemical reaction vessels and heat exchangers because of its excellent corrosion resistance, but the disadvantage is that the cost is high. Especially when used as structural components, this problem is par

«
1
2
3
4
5
6
7
8
»

Steel