Prebaked anode steel yoke

Prebaked anode steel yoke is an essential device in the anodic guide rod during the production of electrolytic aluminum. It plays a connecting role between the anode and the anode. The anode is composed of aluminum guide rod and anode carbon block.
Prebaked anode steel yoke aluminum slag electrolyte

As consumables, the anode steel claw and its aluminum guide rod will be exhausted after one month of production in the electrolysis workshop. At this time, the old anode assembly needs to be removed and replaced with a new one.However, aluminum slag and electrolytes will remain on the old guide rod.Electrolyte cleaning will also take place in the anode assembly shop.

Prebaked anode steel yoke protection ring
In addition to the removal of the electrolyte around the anode steel claw, the phosphorus iron ring wrapped in the steel claw should be removed, where the phosphorus iron ring pressure extractor should be used for pressure removal, and finally the shot blasting should be cleaned for recycling.
Fabrication process and production of Prebaked anode steel yoke
Besides recycling, anode steel claws are also professionally made.The electric arc furnace and medium frequency furnace are used to refine the rare earth to ensure the gas content in the molten steel and the conductivity and strength of the steel claws.

Prebaked anode steel yoke type

General production of parallel three - claw, four - claw, four - dimensional four - claw, six - claw, eight - claw, double - anode steel claw models.
Prebaked anode steel yoke technical standard
Anode steel claw is consumable in the process of electrolytic aluminum production, and its consumption degree and replacement frequency are generally limited by the production of electrolytic workshop.The transfer of the anode assembly is performed only when the busbar is lifted and the anode is changed.Generally, when the anode carbon block is consumed to 15~18 days, the bus bar shall be lifted once and the anode assembly shall be adjusted once.
However, the consumption of the anode carbon block is about 30 days, at which time the anode needs to be replaced. Every anodic replacement is the consumption of the anode steel claw, and the replacement cycle of the steel claw is 30 cycles, i.e., 30 months, with an average of every two and a half years.Sometimes depending on the specific degree of consumption, this is the anode steel claw.
Aluminium Sheets
Aluminium Sheets

View Details
Aluminium Coils
Aluminium Coils

View Details
Aluminium Foils
Aluminium Foils

View Details
Aluminium Strips
Aluminium Strips

View Details
Aluminium Circles
Aluminium Circles

View Details
Coated Aluminium
Coated Aluminium

View Details
Mirror Aluminum
Mirror Aluminum

View Details
Stucco Embossed Aluminum
Stucco Embossed Aluminum

View Details