Standard Analysis of Aluminum Alloy Materials

Mar 31, 2023

Because aluminum alloy cable is to new material of aluminum alloy conductor, so the most authoritative national energy industry standard the rated voltage 0.61kV aluminum alloy conductor cross-linked polyethylene insulation cable "door of technical secondary school formulation of the assessment of qualified conductor aluminum alloy and aluminum alloy cable standard terms and conditions, and points out the basic characteristics of the conductor of the requirements. Specific examples are as follows:

One, ASTMB80005 (2011) and the national standard of the national standard AA-8000 of the r aluminum alloy chemical composition.

Two, tensile strength: 98Mpa-159Mpa.

Three, the extension rate: 10% and above.

Four, the electric conductivity: 61%IACS and above (20 degree DC resistance 0.028264 and below).

Five, material density: AA8000 aluminum alloy density 2.71g/cm3 and above.

Six, 100 hours of compressive creep test: test conditions, test temperature of 90 degrees, the test pressure stress 76Mpa, 100 hours of examination time, then watch conductor aluminum alloy creep curve and the copper conductor creep curve comparison.

Only these criteria for the evaluation of the provisions of the same time (Note: it is also met), is a qualified conductor of aluminum alloy material.