Prebaked anode yoke bracket

Jun 24, 2023

Prebaked anode yoke bracket is an essential device in the anodic guide rod during the production of electrolytic aluminum. It plays a connecting role between the anode and the anode. The anode is composed of aluminum guide rod on the anode and anode carbon block on the bottom.
Prebaked anode yoke bracket aluminum slag electrolyte
As consumables, the anode steel claw and its aluminum guide rod will be exhausted after one month of production in the electrolysis workshop. At this time, the old anode assembly needs to be removed and replaced with a new one.However, aluminum slag and electrolytes will remain on the old guide rod.Electrolyte cleaning will also take place in the anode assembly shop.

Prebaked anode yoke bracket protection ring
In addition to the removal of the electrolyte around the anode steel claw, the phosphoric iron ring wrapped in the steel claw should be removed, where the phosphoric iron ring pressure extractor should be used for pressure removal, and finally the shot blasting should be cleaned for recycling.
Fabrication process and production of anode steel claw
Besides recycling, anode steel claws are also professionally made.The electric arc furnace and medium frequency furnace are used to refine the rare earth to ensure the gas content in the molten steel and the electrical conductivity and strength index of its steel claws.
Prebaked anode yoke bracket type
General production has parallel three - claw, four - claw, four - dimensional four - claw, six - claw, eight - claw, double - anode steel claw models.
Anode steel claw technical standard
Anode steel claw is consumable in the process of electrolytic aluminum production, and its consumption degree and replacement frequency are generally limited by the production of electrolytic workshop.The transfer of the anode assembly is performed only when the busbar is lifted and the anode is changed.Generally, when the anode carbon block is consumed to 15~18 days, the bus bar shall be lifted once and the anode assembly shall be adjusted once.
However, the consumption of the anode carbon block is about 30 days, at which time the anode needs to be replaced. Every anodic replacement is the consumption of the anode steel claw, and the replacement cycle of the steel claw is 30 cycles, i.e., 30 months, and the average replacement cycle is two and a half years.Sometimes depending on the specific degree of consumption, this is the anode steel claw.

Prebaked anode yoke bracket

Aluminium Sheets

Aluminium Coils

Aluminium Foils

Aluminium Strips

Aluminium Circles

Coated Aluminium

Mirror Aluminum

Stucco Embossed Aluminum

Aluminum