Coated Aluminum Roll Jacketing Coil

Feb 03, 2023

Coated Aluminum Roll Jacketing Coil

coating aluminum roll jacketing is available in a variety of standard and special colors. It is also available, on special order,with an outer finish of epoxy, modified polyester, vinyl and other specially pigmented coatings. The inside of the aluminum is coated with a poly moisture retarder that provides an excellent resistance to moisture and has excellent abrasion protection during installation. The Aluminum Jacketing is cut and rolled to fit each size of pipe insulation correctly. Use the chart to determine the size of the jacketing needed for the pipe insulation that you are trying to cover. Aluminum jacketing is good for mechanical abuse and for weathrizing exterior pipes. Aluminum jacketing can be installed with either drill screws or banding and seals (fab straps).

Aluminum Coating Jacketing is manufactured using type 3003,1060,1100, or 5005 alloy and Temper is H-44. The jacketing is available in thickness of 0.3mm~1.0mm

Coated Aluminum Roll Jacketing Specification:

Alloy: 3003,1060,1100,5005
Temper: H44
Chemical composition In accordance with DIN EN 573-3
Thickness 0.30 – 1.0 mm
Width 86 – 650 mm, also multiple cut
Inside diameter 405mm, 505mm
Outside diameter Up to 1,800 mm
Coating on front side One-coat or two-coat polyester lacquer
Coating on reverse side Protective lacquer coating

Coated Aluminum Roll Jacketing Application :

1. It can be used for the protection of pipes, fittings and equipments.
2. It can also be used for the jacketing of the equipments, instruments and tanks.